To List The Emulation Probe Commands; To Use The Built-In Commands - Agilent Technologies E5900B User Manual

To list the emulation probe commands

To list the emulation probe command line mode commands enter:
? *
To get help on an individual command enter
? <command name>
Examples
? cf
? cf speed

To use the built-in commands

Here are a few commonly used built-in commands:
Useful built-in commands
b Break—go into the background monitor state
cf Configuration—read or write configuration options
help Help—display online help for built-in commands
init Initialize—init -c re-initializes everything in the emulation
probe except for the LAN software and configuration settings
lan configure LAN address
m Memory—read or write memory
reg Register—read or write a register
mtest Memory test—test target memory system
r Run—start running user code
rep Repeat—repeat a command or group of commands
rst Reset—reset the target processor
s Step—do a low-level single step
ver Version—display the product number and firmware version of the
emulation probe
Agilent Technologies Emulation for the PowerPC 400/600/700
Chapter 12: Troubleshooting the Emulation Probe
Help on configuration questions
Help on configuration speed question
Status Lights
157