Examples Of Built-In Commands - Agilent Technologies E5900B User Manual

Chapter 12: Troubleshooting the Emulation Probe
Status Lights
Use help command_name to see the command syntax. For example, enter
help m to get help on the memory command.
The prompt indicates the status of the emulation probe:
Emulation probe prompts
U Running user program
M Running in background monitor
p No target power
R Emulation reset
r Target reset
c Checkstop
? Unknown state

Examples of built-in commands

The following examples are specific to PowerPC 6XX and 7XX processors. You
will need to modify these examples if you are using a PowerPC 4XX target
system.
Examples
To set register GPR0, and then view GPR0 to verify that it was set, enter:
R>rst -m
M>reg GPR0=ffff
M>reg GPR0
reg GPR0=0000ffff
To break execution and then step a single instruction, enter:
M>b
M>s
PC=xxxxxxxx
M>
To determine what firmware version is installed in the emulation probe,
enter:
M>ver
158 Agilent Technologies Emulation for the PowerPC 400/600/700