Troubleshooting Guide; Step 1: Telnet To The Emulation Probe; If You Cannot Connect To The Emulation Probe; Step 2: Check The Prompt - Agilent Technologies E5900B User Manual

Troubleshooting Guide

If you have trouble using the emulation probe, the following steps may help
you identify the problem:

Step 1: Telnet to the emulation probe

Use telnet to connect to the emulation probe across the LAN. (For
instructions on how to do this, see "Verifying LAN Communications" on
page 51.
The emulation probe must be reachable via LAN before you can use it.

If you cannot connect to the emulation probe

If you cannot ping or telnet to the emulation probe ("Verifying LAN
Communications" on page 51):
• See "Problems with the LAN Interface" on page 171.
• If you need to change the LAN parameters of the emulation probe, see
Chapter 3, "Connecting the Emulation Probe to a Site LAN," on page
40.

Step 2: Check the prompt

Once you have connected to the emulation probe, press the Enter key a few
times and look at the prompt which is displayed.
If a telnet connection to the emulation probe
displays the prompt "->"
The "->" prompt indicates that the firmware loaded into the emulation probe is
not compatible with the "target board adapter" which is located inside the
emulation probe.
Agilent Technologies Emulation for the PowerPC 400/600/700
Chapter 12: Troubleshooting the Emulation Probe
Troubleshooting Guide
149