To Configure Reset Vector Address (Powerpc 603Ei, 745, 755); To Configure Power On Reset Operation (Powerpc 745, 755); Power On Reset Behavior - Agilent Technologies E5900B User Manual

To configure reset vector address
(PowerPC 603ei, 745, 755)
The reset vector address configuration item tells the emulation probe which
reset vector the target hardware is using. This value does not set the reset
vector. This is done by the hardware.
Vector Address Configuration
Command
cf vector=fff00100
cf vector=00000100
To configure power on reset operation
(PowerPC 745, 755)
The power on reset configuration item determines whether the emulation
probe asserts a rst command upon target system power up.
Reset Configuration
Command
cf pwrrst=on
cf pwrrst=off
Agilent Technologies Emulation for the PowerPC 400/600/700
Chapter 7: Configuring the Emulation Probe
Emulation module configured for
Emulation probe is told that fff00100 is the reset vector.
(Default)
Emulation probe is told that 00000100 is the reset vector.
Emulation module configured for
An emulation reset command (rst) is invoked about 1/2
second after the target power transitions on. Subsequent
operation is determined by the "cf reset" configuration
item. (Default)
Target reset operation at the power on transition is
controlled by target. After the target reset the target
processor will typically start running. The emulation
probe will not be involved with the reset or the
subsequent run.
Configuration items
81