To Run Complete Performance Verification Tests Using A Serial Or Telnet Connection - Agilent Technologies E5900B User Manual

3 In the system window, select the emulation probe icon then select
4 Select Start PV.
1 Connect an SMB cable between BREAK IN and TRIGGER OUT.
2 Disconnect the probe/module interconnect cable.
3 Turn off the emulation probe and disconnect the emulation probe from
CAUTION:
4 Connect the emulation probe to your PC or workstation using a serial
5 Use a telnet or a terminal emulator to connect to the emulation
6 Enter the pv 1 command.
See Also
Chapter 12: Troubleshooting the Emulation Probe
Problems with the Emulation Probe
Performance Verification.
The results will appear on screen.
To run complete performance verification tests using a
serial or telnet connection
your target system, then turn the emulation probe on again.
Disconnect the emulation probe from your target system before running the
tests. Running the Target Board Adapter Feedback Test with the target
system connected can damage components on the target system.
or LAN connection, as described in "Connecting the Emulation Probe
to a Site LAN" on page 40.
probe.
Options available for the pv command are explained in the help screen
displayed by typing help pv or ? pv at the prompt.
Examples
Here are some examples of ways to use the pv command.
To execute all of the tests one time:
pv 1
178 Agilent Technologies Emulation for the PowerPC 400/600/700