Agilent E5902B Emulation Migration Kit; Equipment Supplied; Minimum Equipment Required - Agilent Technologies E5900B User Manual

Chapter 1: Overview

Agilent E5902B Emulation Migration Kit

Agilent E5902B Emulation Migration Kit

Equipment supplied

The equipment supplied with your emulation migration includes:
Part Number Description
E8130-66503 Target board adapter (formerly called cable board).
This board customizes the emulation probe for a particular
target type. It is called "6XX cable board" on the contents list.
E8130-00201 Front panel for the emulation probe.
E8130-68701 Tool kit: 1/4 inch wrench, Torx T-10 screwdriver, and a #1
Phillips screwdriver.
E3494-61604 16-pin JTAG ribbon cable.
This connects the emulation probe to the target debug port.
B3760A Emulation probe firmware, and logic analyzer software on a
CD-ROM.
E34xx-xxxxx Firmware for the emulation probe on a 3.5-inch disk, for use if
you do not have an Agilent logic analysis system.
E3454-97006 This User's Guide.

Minimum equipment required

The following equipment is required to use the emulation migration:
• An Agilent E5900B emulation probe.
• A method for connecting the emulation probe to the target system. The
target system must have an appropriate JTAG debug port connector. The
target system must meet the criteria described in Chapter 2, "Designing a
Target System for an Emulation Probe," beginning on page 25.
• A host computer such as a PC, a workstation, or an Agilent 16700-series
logic analysis system.
• A user interface, such as a high-level source debugger or the logic analysis
system's Emulation Control Interface.
20 Agilent Technologies Emulation for the PowerPC 400/600/700