Powerpc Jtag Interface Connections And Resistors - Agilent Technologies E5900B User Manual

Chapter 2: Designing a Target System for an Emulation Probe
capacitance values.
• See the processor manufacturer's data sheet for rise/fall time
specifications.

PowerPC JTAG interface connections and resistors

The target system must have a 16-pin male 2x8 header connector with
dimensions as shown below.
JTAG Header Connector (top view)
Position 14 of the connector on the target system must not contain a pin. The
cable supplied with the emulation probe can only be installed if pin 14 has
been removed from the target system header.
Place the connector as close as possible to the processor to ensure signal
integrity.
30 Agilent Technologies Emulation for the PowerPC 400/600/700