Connecting Headphones; Installing Batteries In The Remote Control; Powering On The System - Polycom V500 Administrator's Manual

Polycom v500: user guide
Hide thumbs Also See for V500:
Table of Contents

Advertisement

Administrator's Guide for the V500 System

Connecting Headphones

Installing Batteries in the Remote Control

Powering On the System

2 - 4
You can connect headphones to the V500 system to listen to your calls
privately.
The back panel view on page
The remote control uses three AAA batteries, which are included with the
system.
To install batteries in the remote control:
1. Remove the battery cover from the back of the remote control.
2. Refer to the diagram inside the remote control, and install the batteries in
the orientation shown.
3. Reinstall the battery cover on the remote control.
The system notifies you when the batteries need to be replaced.
The V500 system has an external power supply.
Do not use a power supply other than the one supplied with your V500 system.
Using the wrong power supply will void the warranty and may damage your system.
The back panel view, shown on page 2-1, shows the location of the power
connector and power switch.
To power on the system:
1. Make sure you have connected all equipment to the system, and then
connect the power cord to a wall outlet.
2. Power on the monitor.
3. Press the power switch located at the back of the system.
2-1
shows the location of the headphone jack.

Advertisement

Table of Contents
loading

Table of Contents