Connecting Headphones - Polycom V500 System Administrator's Manual

Administrator's Guide for the V500 System

Connecting Headphones

Installing Batteries in the Remote Control
Powering On the System
2 - 4
You can connect optional headphones to the V500 system to listen to your calls
privately.
The back panel view, shown on page 2-1, shows the location of the headphone
jack.
To connect headphones to the system:
Connect the headphone cable to the headphone jack on the back of the
system.
The remote control uses three AAA batteries, which are included with the
system.
To install batteries in the remote control:
1. Remove the battery cover from the back of the remote control.
2. Refer to the diagram inside the remote control, and install the batteries in
the orientation shown.
3. Reinstall the battery cover on the remote control.
The V500 system has an external power supply.
Do not use a power supply other than the one supplied with your V500 system.
Using the wrong power supply will void the warranty and may damage your system.
The back panel view, shown on page 2-1, shows the location of the power
connector and power switch.
To connect power and power on the system:
1. Connect the power supply to the power connector on the back of the
system.
2. Connect the power cord to the power supply.