Administrator's Guide for the V500 System
Setting the Dialing Rules
Placing a Test Call
3 - 32
If your system is connected to a private network and also to a public network,
you may need to specify the codes and prefixes necessary for dialing other
systems.
To set the dialing rules:
1. Go to System > Admin Settings > Global Services > Dialing Rules.
2. Configure these settings:
Setting
Always Dial Area
Code
Dial 1+ for all USA
calls
When you finish configuring the system, you can use one of the sample
numbers in the directory to test your setup.
To place a test call:
1. On the Place a Call screen, select
2. Select Group.
3. Select Sample Sites and highlight a location.
4. Press
Call on the remote control.
You can also find a list of worldwide numbers that you can use to test your
V500 system at www.polycom.com/videotest.
Description
Specifies that calls to sites in the same area code must
include the area code.
Specifies that calls to systems in the United States must
include a "1" before the area code.
Note: Even if you have this setting enabled, you may need
to dial 1 and the area code when calling long distance over
ISDN within your same area code.
Directory.