Configuring The System To Use A Gateway - Polycom V500 Administrator's Manual

Administrator's Guide for the V500 System
3 - 18
To use Avaya features, V500 systems must be configured as follows:
• Avaya option key installed
• Registered with the ACM
• H.239 enabled for content sharing
• Auto-answer modes disabled
To install the Avaya option key:
1. Obtain a license number from Avaya, then enter that online at the
Polycom Resource Center, along with your V500 system serial number.
This returns a key code for the Avaya option.
2. On the V500 system, go to System > Admin Settings > General Settings
> Options and enter the key code for the Avaya option.
To configure the V500 system to use Avaya network features:
Go to this screen:
Gatekeeper
System > Admin Settings > Network >
IP > H.323 Settings > Next
Call Preference
System > Admin Settings > Network >
IP > Call Preference
Call Settings
System > Admin Settings > General
Settings > System Settings > Call
Settings

Configuring the System to Use a Gateway

A gateway performs code and protocol conversion between H.323 (IP) and
H.320 (ISDN), so that users on different networks can call one another. If the
system is configured to use a gateway, you must also configure it to use a
gatekeeper.
Configure these settings:
Set Use Gatekeeper to Specify with
PIN.
Enter the H.323 Extension (E.164)
provided by the ACM administrator.
Enter the ACM IP address for
Gatekeeper IP Address.
Enter the Authentication PIN provided
by the ACM administrator.
Set Enable H.239.
Set Auto-Answer Point to Point to No.