Optional Equipment Set-Up; Connecting To A Bri Network Interface; Connecting Headphones - Polycom V500 Administrator's Manual

Administrator's Guide for the V500 System

Optional Equipment Set-up

Connecting to a BRI Network Interface

Connecting Headphones

2 - 6
This section describes how to connect optional components to the V500 system.
The V500 system is available with the optional BRI network interface, which
allows you to make ISDN calls.
You may need an NT-1 device if your site does not use an internal telephone
system (PBX). A PBX or an NT-1 device provides the S/T interface that the
system's BRI network interface requires.
To install the BRI network interface:
Make sure the system is powered off.
1.
2. Connect the BRI cable from the BRI connector on the back of the system to
ISDN or to your NT-1 device, as appropriate.
3. If you are using an NT-1 device, connect it to the ISDN.
You can connect headphones to the V500 system to listen to your calls privately.
To connect headphones to the system:
>> Connect the headphone cable to the headphone jack on the back of the system.
BRI
BRI
BRI connector
Headphone jack
DC IN 12V
LAN
DC IN 12V
LAN
www.polycom.com/videodocumentation