Connecting To The Mcu - Polycom RMX 1500 Quick Installation And Configuration Manual

1
Insert the USB key with the modified IP addresses into the USB port
on the front panel.
2
Power the RMX ON. The ON/OFF button is lit (ON).
System power-up sequence may take approximately 10 minutes.
During this time, the parameters in the lan.cfg file are uploaded
from the USB key to the RMX's memory and applied.
Wait for the upload process to complete. Initially all the READY/
IN USE/ERROR LEDs flicker and flash. Upload is completed when
all the LEDs turn off and only the red ERROR LED remains ON.
It remains ON until the Default IP Network Service is configured.
Do not remove the USB key from the RMX until the connection
with the RMX is established.
Product Registration and Activation Key Retrieval
Before starting the initial configuration process, register the RMX at the
Polycom Resource Center website and download the product activation
key file to the computer you will use for the configuration:
1
Using a Web browser, connect to
2
Login with your Email Address and Password or register as a new
user.
3
Select the Product Registration link.
4
Follow the on-screen instructions for Product Registration and
Product Activation. (The RMX's serial number is on a sticker on the
back of the unit, if needed.)
5
Write down the Product Activation Key number or copy it for later
use.
1
Start the RMX Web Client application on the workstation by
entering in the browser's address line the IP Address of the control
unit as defined in the USB key in the format:
http://<Control Unit IP Address>
First Entry Power-up

Connecting to the MCU

http://portal.polycom.com
and pressing Enter.
.
5