Adjusting Or Replacing The Ozone Generator Uv Lamp; Figure 7-9. O 3 Generator Uv Lamp Assembly - Teledyne T750 User Manual

A
7.8.
DJUSTING OR
This procedure details the steps for replacement and initial adjustment of the ozone
generator lamp. If you are adjusting an existing lamp, skip to Step 8.
1. Turn off the calibrator.
2. Open the calibrator's panels.
3. Locate the O
4. Remove the two setscrews that hold the UV lamp in place and gently pull out
5. Inspect the o-ring beneath the UV lamp retaining ring and replace if
6. Install the new lamp in the O
7. Tighten the two set screws.
8. Turn on instrument and allow it to stabilize for at least 30 minutes.
9. Run an Auto Leak check (Section 7.4).
10. Run an Ozone Generator calibration (see Section 6.3).
083730750B DCN8606
R O
EPLACING THE ZONE
generator assembly (Figure 2-4).
3
Figure 7-9. O Generator UV Lamp Assembly
3
the old lamp.
damaged.
The lamp should be able to be rotated in the assembly by grasping the lamp
cable.
Ensure that it is fully seated in the O
G UV L
ENERATOR AMP
generator housing
3
generator housing.
3
131