Generate>Sequence: Automatic Operation Using Sequences; Activating A Sequence From The Touchscreen; Activating A Sequence With The Internal Timer; Figure 4-13. Sample Generate Gpt Page - Teledyne T750 User Manual

In the Generate page, press the GPT button and configure the parameters according to:
•
•
•
Then press the Generate button.
G
ENERATE
The calibrator can be set up to perform automatic calibration sequences. Each sequence is
a database of single or multiple steps where each single step is an instruction that causes
the instrument to perform a calibration operation. These steps are grouped under a user-
defined sequence name, and each sequence is configured in the Setup>Sequence menu
(Section 3.3.7). These sequences can perform all of the calibration operations available
(see Table 3-2) for manual operation; they can be configured to be triggered by any of
several methods:
•
•
•
•
•

Activating a Sequence from the Touchscreen

In the Generate menu, press the SEQUENCE button, and in the EXECSEQ field that
appears, select the name of the sequence in the scrollable list and press the Generate button.
Suspend the Sequence by pressing the Standby button.

Activating a Sequence with the Internal Timer

Typically a sequence will start automatically at the time that was input when first
configured (Section 3.3.7) if the Timer was enabled. To enable the Timer or change the
settings, navigate to the Setup>Sequences menu, select the sequence by name and in the
Timer field check the Enable box. Press the Edit button to either view or change the Timer
settings.
96
NO source gas concentration and units
Target O3 concentration (equal to the target NO
generated) and units
Total Flow in SLPM for the mixture output

Figure 4-13. Sample Generate GPT Page

>SEQUENCE: A
UTOMATIC
touchscreen
internal timer: preprogrammed in the Sequence
the external digital control inputs
communications interface (such as RS-232 or Ethernet)
sub-processes in another sequence
concentration to be
2
O U S
PERATION SING EQUENCES
083730750B DCN8606