Figure 3-8. Das Download Page; Figure 3-9. Configuration Transfer - Teledyne T750 User Manual

2. To copy the data to the flash drive, press the Start button next to "Download
3. When complete, as indicated in the Status field, the Cancel button becomes
U
PDATING
It is possible to check for firmware updates, reload current firmware, and to update
firmware remotely. Because this is a maintenance item and there is more than one way to
implement an update, instructions are provided in Section 7.3.
T
RANSFERRING
Once an instrument is configured, the same configuration can be copied to other
instruments of the same Model. This encompasses essentially anything the user can
configure and does not apply to instrument-specific settings such as those that are
configured at the factory for calibration.
1. In the source instrument, navigate to the Home>Utilities>USB
2. Insert a flash drive into either of the two front panel USB ports.
3. When the Status field indicates that the USB drive has been detected,
4. When the Status field indicates that the download is complete, remove
5. In the target instrument, navigate to the Home>Utilities>USB
083730750B DCN8606

Figure 3-8. Das Download Page

DAS Data from Instrument." (The Cancel button will be enabled).
the Done button: press Done and then remove the flash drive.
F
IRMWARE
C
ONFIGURATION TO

Figure 3-9. Configuration Transfer

Utilities>General page.
press the "Download Configuration from Instrument" Start button.
the flash drive.
Utilities>General page.
O I
THER NSTRUMENTS
61