Manual Reload/Update Procedures; Performing The Auto Leak Check; Leak Check Equipment And Calibrator Setup; Figure 7-3. Manual Update Page (And Other Utilities) - Teledyne T750 User Manual

M R
ANUAL
To reload or update firmware manually, first contact Technical Support to obtain the
applicable file(s): sda_techsupport@teledyne.com / 800-324-5190.
1. Follow Technical Support's instructions for copying the firmware files to
2. Navigate to the Utilities>USB Utilities>General menu.

Figure 7-3. Manual Update Page (and other utilities)

3. Insert a flash drive into a front panel USB port and wait for the Status
4. In the Update Firmware field, press the Check button for the instrument
5. Press the Install button and note the messages in the Status field at the
6. When complete, as indicated in the Status field, press the Done button,
7. Power off and restart the instrument to complete the new firmware
P
7.4.
ERFORMING THE
L C
EAK HECK
Make sure to have ready:
•
Or, for T750 models with the O
•
•
•
124
/U P
ELOAD PDATE ROCEDURES
a flash drive.
field to indicate that the drive has been detected.
to determine whether the firmware on the flash drive is more recent than
what is currently installed. Once it's been determined that the firmware
is new, the Install button will be enabled; if the firmware version on the
flash drive is the same as or older than the current firmware of the
instrument, the Install button will not be enabled.
bottom of the page. Use the Cancel button if necessary.
which replaces the Cancel button, and remove the flash drive.
installation.
A L C
UTO EAK HECK
E C
QUIPMENT AND ALIBRATOR
One 1/4" pneumatic cap for the CAL GAS OUT fitting on T750 basic
configuration,
generator with photometer installed:
3
Two (2) 1/4" Pneumatic caps (for EXHAUST and CAL GAS OUT ports)
One (1) 1/8" Pneumatic Cap (for internal vent)
Two (2) pneumatic tube clamps, KIT000322Setup for Auto Leak Check
S
ETUP
083730750B DCN8606