Table of Contents
Advertisement
APPENDIX A – SYSTEM ERROR CODES
A1. Base Controller Error Codes produced by the User Interface
Error Code
U24
U25
U26
U27
U28
U29
U34
U35
U36
U37
U38
A2. Error Codes produced by the Coil
Error Codes
C01
C02
C03
C04
C05
C06
C07
C08
C09
C10
C11
C12
C13
C21
C22
C23
C24
C25
C26
C27
C28
C29
C30
C31
© The Magstim Company Limited
Description
UI Power Supply Failure
Stack underflow
Stack overflow
RTS overrun
Watchdog Timeout
ROM Checksum Incorrect
No serial communications
Loss of communication
Bad NVRAM Checksum
Battery Voltage Low
Bad External Flash Checksum Detected.
Description
ROM Checksum Incorrect.
EEPROM Checksum Incorrect.
Invalid coil Category.
Invalid Power Identification .
Temperature sensor circuit failure.
Bad Serial command or received data checksum.
Internal Software Error.
Invalid Coil Temperature ID.
Invalid temperature algorithm coefficient.
Coil controller malfunction.
Rapid coil algorithm constant checksum incorrect.
Invalid enhanced power byte. (1's compliment comparison test failed)
Average power checksum incorrect.
Coil Disconnected/ Coil Under Temperature.
Brown Out Detected.
No serial Communications.
Bad Serial command of received data checksum (outside TRIGGATE).
EMC Detected (Coil adapter only).
Invalid Coil Power Identification (Coil adapter only).
Hardware Stop activated.
Watchdog Timeout.
Temperature Interlock 3 activation.
Coil stop line fault.
Air Extraction Unit Not Operating Correctly (3530-00 coil only)
55
Magstim Rapid²
Operating Manual
MOP03-EN-03
Advertisement
Table of Contents
