Table of Contents
Advertisement
4.4.1.6
Press the Display button (green when selected)
to access the Display panel.
Status: Select the Status window to turn the
Amplitude Cursors on and off. The default
setting is OFF.
Channel 1: Select the Channel 1 window to
show Channel 1 only in the trace window.
Channel 2: Select the Channel 2 window to
show Channel 2 only in the trace window.
Both: Select the Both window to show both
traces simultaneously in the trace window.
4.4.1.7
Select Save Traces to save the current trace. If a file is already open, the trace will be saved to this
file. Alternatively, go to File Maintenance and save the trace to a file. (See Section 4.4.6)
4.4.1.8
The Coil Status panel will show the temperature and type of coil.
4.4.1.9
The System Status panel shows the system status. If a charge delay has been set, a stopwatch
symbol (
4.4.1.10 Trace Window
The Trace window will be updated when stimulation occurs. The maximum update rate for the trace
window is 4 times a second, depending on the amount of information to be displayed.
Print: For Print operations see Section 4.6.8
Repetitive: This takes the user to the Repetitive Setup Screen. (See Section 4.4.2 & 4.4.3)
Session: This takes the user to the Session Setup screen (see Section 4.4.4)
File: This takes the user to the File Maintenance screen (see Section 4.4.6).
Options Menu: Selection of this option will return the user to the Options Menu screen.
© The Magstim Company Limited
Display Panel
Save Traces
Coil Status Panel
System Status Panel
) will be displayed.
Figure 4.17: Display Panel Window
30
Magstim Rapid²
Operating Manual
MOP03-EN-03
Advertisement
Table of Contents
