Magstim Rapid² User Interface - MAGSTIM Rapid2 Operating Manual

Hide thumbs Also See for Rapid2:

Table of Contents

Magstim Rapid² User Interface

3.3

The Rapid² UI is a touch screen user interface by which the user controls the Magstim Rapid² system.

Front view

3.3.1

All operating functions described in this section assume that the mains power switch, located on the

rear panel of the Rapid², is switched on

(5)

3.3.1.1

The Magstim Rapid² system can be put into the armed mode by momentarily pushing the Green RUN

button. This can only be achieved if the stimulating coil is connected to the coil output socket.

3.3.1.2

The Magstim Rapid² can be triggered to deliver the protocol by pressing the yellow TRIGGER button.

Note: It may be necessary to also activate the coil interlock buttons with some Magstim stimulating

coils in order to trigger the system.

3.3.1.3

The Magstim Rapid² can be disarmed and put into a safe state by pushing the red STOP button. In

this mode the system will discharge internally.

3.3.1.4

This control allows the user to change the screen-selected parameter to the desired value. It is

therefore used to alter screen settings as well as changing the power output of the stimulator.

Figure 3.9: Detailed front panel of Rapid² UI.

Run Button* (1)

Trigger Button* (2)

System Stop Button* (3)

Output Control* (4)

Magstim Rapid²

Operating Manual

(1)

(2)

(3)

(4)

MOP03-EN-03

Table of Contents