Table of Contents
Advertisement
2
The Magstim Rapid
or the user of the equipment should assure that it is used in such an environment.
Immunity Test
Conducted RF
3 Vrms
IEC 61000-4-6
150 kHz to
80 MHz
Radiated RF
3 V/m
IEC 61000-4-3
80 MHz to
2,5 GHz
NOTE 1 At 80 MHz and 800 MHz, the higher frequency range applies.
NOTE 2 These guidelines may not apply in all situations. Electromagnetic propagation is affected by absorption
and reflection from structures, objects and people.
a
Field strengths from fixed transmitters, such as base stations for radio (cellular/ cordless) telephones and land
mobile radios, amateur radio, AM and FM radio broadcast and TV broadcast cannot be predicted theoretically with
accuracy. To assess the electromagnetic environment due to fixed RF transmitters, an electromagnetic site survey
should be considered. If the measured filed strength in the location in which the Magstim Rapid
exceeds the applicable RF compliance level above, the Magstim Rapid
normal operation. If abnormal performance is observed, additional measures may be necessary, such as re-
orienting or relocating the Magstim Rapid
b
Over the frequency range 150 kHz to 80 MHz, field strengths should be less than [V
© The Magstim Company Limited
Guidance and Manufacturer's Declaration – Electromagnetic Immunity
System is intended for use in the electromagnetic environment specified below. The customer
IEC 60601
Compliance
Test Level
[V
] V
1
[E
] V/m
1
2
System.
Electromagnetic environment - guidance
Level
Portable
equipment should be used no closer to any part of
the Magstim Rapid
the recommended separation distance calculated
from the equation applicable to the frequency
transmitter.
Recommended separation distance
3,5
] P
d = [
V
1
3,5
] P
d = [
E
1
7
] P
d = [
E
1
Where P is the maximum output power rating of the
transmitter in watts (W) according to the transmitter
manufacturer
separation distance in metres (m).
Field Strengths from fixed RF transmitters, as
determined by an electromagnetic site survey,
should be less than the compliance level in each
frequency range.
Interference may occur in the vicinity of equipment
marked with the following symbol:
69
and
mobile
RF
communications
2
System, including cables, than
80 MHz to 800 MHz
800 MHz to 2,5 GHz
and
d
is
the
b
2
System is used
2
System should be observed to verify
] V/m.
1
Magstim Rapid²
Operating Manual
recommended
a
MOP03-EN-03
Advertisement
Table of Contents
