Table of Contents
Advertisement
Operation
4.4
1.
Apply mains power to the Rapid² system by switching the mains power switch on the rear panel
of the Rapid² Main Frame and, if relevant the mains power switch on the rear panel of the
Magstim Plus1 to the ON (I) position.
2.
Switch on the system using the ON/OFF/
STANDBY button on the front of the Rapid² Main
Frame. The UI will activate automatically and will
display the welcome screen (Figure 4.10).
Note: The system will fully initialise and the
Options Menu will appear after 15 seconds.
Pressing the Continue Button before the system
has fully initialised gives access to the following
options:
The system needs to be fully initialised before Repetitive mode and Session mode are
accessible.
3.
When in the Main Options Menu (Figure 4.10), select the desired mode of operation. These
modes of operation being:
Single Pulse (MEP):
Selecting this option will call up the Single
Pulse Mode Screen. (See Section 4.4.1)
This allows the system to be fired at a
maximum rate of 1Hz, up to 100% power and
0.5 Hz from 101-110%. It also allows an MEP
module to be configured.
Repetitive Mode
Selecting this option will call up the Repetitive
Mode Set-up Screen. (See section 4.4.2 &
4.4.3) This allows the system to run a user
defined train of pulses from a single trigger.
Session Mode
Selecting this option will call up the Session Mode Setup Screen. (See section 4.4.4) This allows
the system to run a series of separately defined trains of pulses from a single trigger.
4.
If required, system options and file maintenance can also be accessed from this window.
System
Selecting this option will call up the Systems Options Menu Screen. (See Section 4.4.5)
File Maintenance
Selecting this option will call up the File Maintenance Screen. (See section 4.4.6)
5.
When in the desired mode of operation, select the desired protocol to be delivered, (e.g.
stimulating power, stimulation frequency, train duration and inter-train delay).
© The Magstim Company Limited
Single Pulse Mode,
System,
File Maintenance
Figure 4.10: Welcome Screen
Figure 4.11: Main Options Menu
25
Magstim Rapid²
Operating Manual
MOP03-EN-03
Advertisement
Table of Contents
