Table of Contents
Advertisement
Magstim Rapid² Plus¹
3.2
The Rapid² Plus¹ uses the same modules as the Super Rapid² with the addition of the Plus¹ module
which has an additional PSU. This allows stimulation to occur at higher frequencies for a given power
level to be delivered to the patient.
Front view
3.2.1
The front panel, shown below, allows control of the Standard Rapid² Plus¹ and provides the
connection for the stimulating coil.
All operating functions described in this section assume that the mains power switch, located on the
rear panel, is switched on
(1)
(2)
(4)
(6)
(5)
3.2.1.1
This switch toggles the operational state of the Rapid
3.2.1.2
The armed indicator illuminates when the unit is armed and high voltages are present on the system.
© The Magstim Company Limited
(3)
Figure 3.5: Detailed front panel of Rapid² Plus¹.
On/Off/Standby* (1)
Armed Indicator* (2)
2.
10
Magstim Rapid²
Operating Manual
(9)
(10)
(7)
(8)
(11)
(12)
MOP03-EN-03
Advertisement
Table of Contents
