Appendix A - System Error Codes - MAGSTIM 2002 Operating Manual

Magstim 200 2
Operating Manual
APPENDIX A - SYSTEM ERROR CODES
Error codes produced by the User Interface
Error Code
Description
U24 POWERDOWN
U25 Stack underflow
U26 Stack overflow
U27 RTS overrun
U28 Watchdog Timeout
U29 ROM Checksum Incorrect
U30 Unexpected RESET
U31 Unknown serial interrupt
U32 CSIO overrun
U33 DebuQ error
U34 No serial communications
U35 Loss of communication
U36 Bad NVRAM Checksum
Error codes produced by the Coil
Error Codes Description
C01 ROM Checksum Incorrect.
CO2 EEPROM Checksum Incorrect.
C03 Invalid coil CateQorv.
C04 Invalid Power Identification .
C05 Temperature sensor circuit failure.
C06 Bad Serial command or received data checksum.
CO? Internal Software Error.
C08 Invalid Coil Temperature ID.
C09
Invalid temperature algorithm coefficient.
C10 Coil controller malfunction.
C11 Rapid coil algorithm constant checksum incorrect.
C12 Invalid enhanced power byte. (1's compliment comparison test failed)
C13 Average power checksum incorrect.
C21 Coil Disconnected/ Coil Under Temperature.
C22 Brown Out Detected.
C23 No serial Communications.
C24 Bad Serial command of received data checksum (outside TRIGGATE).
C25 EMC Detected (Coil adapter only).
C26 Invalid Coil Power Identification (Coil adapter only).
C27 Hardware Stop activated.
C28 Watchdog Timeout.
C29 Temperature Interlock 3 activation.
C30 Coil stop line fault.
© The Magstim Company Limited 17 MOP01-EN-01