MAGSTIM Rapid2 Operating Manual page 39

Magstim Rapid²
Operating Manual
Add/Copy Line: Selection of this option (press the window to select) enables the user to copy the
session line settings of the selected line and copy them into the next line.
Delete Line: Selection of this option will delete the highlighted line.
Delete All: This button will delete all lines, allowing the user to start writing a new protocol.
Page Up: Pressing this button will allow the user to move up pages if the protocol has more lines than
will fit on a single screen.
Scroll Up: This allows the user to move up one line at a time.
Scroll Down: Selection of this option allows the user to scroll down one line at the time to view train
lines below those displayed on the screen. There are up to 30 lines available.
Page Down: Moves down a page at a time if the Protocol has more lines than will fit on a single
screen.
Print: For Print operations see Section 4.4.8.
Run Session: Selection of this option will call up the Session Mode screen.
Save Session: Selection of this option will call up the File Maintenance screen (See section 4.4.6)
and allows the user to save the session set up.
Options Menu: Selection of this option will return the user to the Options Menu screen.
4.4.4.2 Session Run Mode
Session Details: Session Details shows a
pictorial representation of 3 lines of the session
running currently and shows the power and total
pulses settings established in the session setup
window.
Channels 1,2 and Both: Selecting Channel 1,
Channel 2 and Both determines whether both
traces are shown simultaneously, or
individually.
Trace Window: The Trace Window will be
updated when stimulation occurs. The
maximum update rate for the trace window is,
4 times a second, depending on the amount of
Figure 4.23: Session Mode Window
information to be displayed.
If the amplitude cursors are active then the last position set for each cursor in Single Pulse Mode will
be displayed. The cursor position will remain fixed until Single Pulse Mode is re-entered.
In order to save the trace, it is necessary to go back to Single Pulse Mode and save the data as
before. The information will remain on each trace window until a new trace is generated, when the
new trace will overwrite the previous trace.
Resume: This Option is available if the system is armed and the previous session was not completed.
This option will return the session to the point at which it was stopped. This will always begin at the
start of the next session line regardless of when the last session line was stopped.
© The Magstim Company Limited 36 MOP03-EN-03