Table of Contents
Advertisement
3.1.1.1
This switch toggles the operational state of the Rapid
3.1.1.2
The armed indicator illuminates when the unit is armed and high voltages are present on the system.
3.1.1.3
The power indicator flashes when the Magstim Rapid² is in standby, and illuminates when the Magstim
Rapid² is on.
3.1.1.4
This socket is used to connect the stimulating coil to the Magstim Rapid².
Note: It is normal for the pin indicated on the label to protrude from the coil socket. This is an
intentional design feature.
3.1.1.5
This LED is continuously illuminated when the Magstim Rapid
on the system. This LED turns RED when a fault is detected in the PSU.
3.1.1.6
The PSU power indicator is OFF when the system is in standby or OFF. It is continuously illuminated
when the system is on.
3.1.1.7
This is the interface by which the user controls the stimulator. See Section 3.3 for further details.
© The Magstim Company Limited
On/Off/Standby* (1)
Armed Indicator* (2)
Power Indicator* (3)
Coil Output Socket* (4)
Figure 3.2: Coil output socket front view Figure 3.3: Coil output socket angled view
Armed/Fault Indicator* (5)
PSU Power Status Indicator* (6)
Rapid² UI (7)
2.
2
is armed and high voltages are present
6
Magstim Rapid²
Operating Manual
MOP03-EN-03
Advertisement
Table of Contents
