Table of Contents
Advertisement
3.1.2.2
The Power switch allows the power supplying the unit to be switched on (labelled I) or off (labelled O).
3.1.2.3
Access for fuse replacement and changing the voltage selector setting. See Section 5.3 for further
details.
3.1.2.4
Power input port on the Rapid² mainframe.
3.1.2.5
The 10A link lead provides powers to the mainframe from the PSU.
3.1.2.6
The HV cable is used to interconnect the high voltage power between the mainframe and the PSU.
3.1.2.7
Mains input port on the Super Rapid² PSU.
3.1.2.8
This 26 way D-Type connector is situated on the rear of the UI and has three rows of pins. It provides
trigger input and output signals. (see Appendix B).
3.1.2.9
This socket is used to connect the pneumatic foot switch to the Magstim Rapid² system. The foot
switch can be used to trigger the instrument when one of the trigger buttons located on the coil is also
pressed. The instrument will continuously charge and discharge if the trigger buttons are pressed and
held.
© The Magstim Company Limited
Mains Power Switch* (2)
Fuse Access and Voltage Selector* (3)
Power Entry Module* (4)
Link Lead* (5)
HV Cable* (6)
Mains input to PSU (Super Rapid² Only)* (7)
Isolated Trigger Port* (8)
Foot Switch Pneumatic Socket* (9)
8
Magstim Rapid²
Operating Manual
MOP03-EN-03
Advertisement
Table of Contents
