HPE ProLiant DL360 Gen11 User Manual page 99

T-10 Torx screwdriver
T-15 Torx screwdriver
Procedure Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
a. Extend the server from the rack .
b. Remove the server from the rack .
4. Remove the access panel .
5. Remove the primary PCI riser cage.
6. Use a T-10 Torx screwdriver to remove the slot 2 bracket from the primary riser cage.
7. Remove the secondary riser blank.
HPE ProLiant DL360 Gen11 Server User Guide 99