HPE ProLiant DL360 Gen11 User Manual page 75

5. Connect the power cord to the power supply.
6. Route the power cord. Use best practices when routing power cords and other cables. A cable management arm is available to help
with routing. To obtain a cable management arm, contact a Hewlett Packard Enterprise authorized reseller.
7. Connect the power cord to the AC power source.
8. Be sure that the power supply LED is green .
Results Results
The installation is complete.
Processor and heatsink options Processor and heatsink options
Subtopics Subtopics
Processor cautions Processor cautions
Installing the processor Installing the processor
Processor cautions Processor cautions
CAUTION: To avoid damage to the processor or system board, only authorized personnel should attempt to replace or CAUTION:
install the processor in this server.
CAUTION: To prevent possible server malfunction and damage to the equipment, multiprocessor configurations must CAUTION:
contain processors with the same part number.
CAUTION: The pins on the processor socket and on the processor are very fragile and easily damaged CAUTION: The pins on the processor socket and on the processor are very fragile and easily damaged . To avoid
component damage, do not touch these pins
processor.
IMPORTANT: Processor socket 1 must be populated at all times or the server does not function. IMPORTANT:
IMPORTANT: If installing a processor with a faster speed, update the system ROM before installing the processor. To IMPORTANT:
download firmware, go to the Hewlett Packard Enterprise Support Center website (
https://www.hpe.com/info/dl360gen11-docs). https://www.hpe.com/info/dl360gen11-docs
Installing the processor Installing the processor
do not touch these pins. Any damage to them might require replacing the system board and/or
HPE ProLiant DL360 Gen11 Server User Guide 75