HPE ProLiant DL360 Gen11 User Manual page 70

6. If the second M.2 SSD is installed on the carrier assembly, repeat steps 1 and 2.
7. Slide the carrier inside the boot device cage and push the button. There will be an audible click when the latch locks into place.
Ensure that the latch is fully engaged.
NOTE: NOTE:
For removal of the drive, follow the same procedure.
Installing the HPE NS204i Boot Device Installing the HPE NS204i Boot Device
Prerequisites Prerequisites
Before beginning installation, make sure that the server is updated with the latest operating system firmware and drivers.
Before you perform this procedure, make sure that you have a T-10 Torx screwdriver available.
About this task About this task
Note the following:
The HPE NS204i-u Gen11 NVMe Hot Plug Boot Optimized Storage Device is a PCIe3 x4 custom form-factor module that includes
two hot pluggable 2280 M.2 NVMe SSDs.
HPE NS204i-u Boot Device auto-creates a RAID1 volume during boot, therefore does not require configuration.
Identify the HPE NS204i Boot Device components.
Procedure Procedure
1. Back up all server data.
2. Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Do one of the following:
Extend the server from the rack .
Remove the server from the rack .
HPE ProLiant DL360 Gen11 Server User Guide 70