HPE ProLiant DL360 Gen11 User Manual page 97

10. If the card requires rear support, install the GPU support bracket.
11. Install the primary PCI riser cage .
12. Install the access panel .
13. Install the server in the rack.
14. Connect each power cord to the server.
15. Connect each power cord to the power source.
16. Power up the server .
Secondary PCI riser options Secondary PCI riser options
The primary PCI riser cage supports the following options:
x16 full-height riser kit
x16 low-profile riser kit
Subtopics Subtopics
Installing a secondary low-profile riser option Installing a secondary low-profile riser option
Installing a secondary full-height riser option Installing a secondary full-height riser option
Installing an expansion board in the secondary riser cage Installing an expansion board in the secondary riser cage
Installing a secondary low-profile riser option Installing a secondary low-profile riser option
Prerequisites Prerequisites
This option requires a dual processor configuration.
Before installing this option, be sure that you have the components included with the hardware option kit.
About this task About this task
When installed, this riser cage provides an additional low profile slot and supports half-length/half-height expansion boards.
Procedure Procedure
1. Observe the following alerts:
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the internal system WARNING:
components to cool before touching them.
CAUTION: To prevent damage to electrical components, properly ground the server before beginning any CAUTION:
HPE ProLiant DL360 Gen11 Server User Guide 97