HPE ProLiant DL360 Gen11 User Manual page 47

8. Install the access panel .
9. Install the server in the rack.
10. Connect each power cord to the server.
11. Connect each power cord to the power source.
12. Power up the server .
Results Results
The installation is complete.
Hard drives Hard drives
Subtopics Subtopics
Drive guidelines Drive guidelines
Installing a hot-plug SAS, SATA or NVMe drive Installing a hot-plug SAS, SATA or NVMe drive
Drive guidelines Drive guidelines
Observe the following general guidelines:
The system automatically sets all drive numbers.
If only one hard drive is used, install it in the bay with the lowest drive number.
For drive numbering, see Drive bay numbering.
The NVMe SSD is a PCIe bus device. Devices attached to a PCIe bus cannot be removed without allowing the device and bus to
complete and cease the signal/traffic flow.
Do not remove an NVMe SSD from the drive bay while the Do Not Remove button LED is flashing. The Do Not Remove button LED
flashes to indicate that the device is still in use. Removal of the NVMe SSD before the device has completed and ceased
signal/traffic flow can cause loss of data.
Drives with the same capacity provide the greatest storage space efficiency when grouped into the same drive array.
HPE ProLiant DL360 Gen11 Server User Guide 47