HPE ProLiant DL360 Gen11 User Manual page 57

7. Install the access panel .
8. Install the server in the rack.
9. Connect each power cord to the server.
10. Connect each power cord to the power source.
11. Power up the server.
Results Results
Use the BIOS/Platform Configuration (RBSU) in the UEFI System Utilities to configure the memory mode.
For more information about LEDs and troubleshooting failed DIMMs, see "Systems Insight Display combined LED descriptions ."
Networking Networking
Subtopics Subtopics
Installing an OCP network adapter Installing an OCP network adapter
Installing a PCIe network adapter Installing a PCIe network adapter
Installing an OCP network adapter Installing an OCP network adapter
Prerequisites Prerequisites
Before you begin this procedure, make sure that the components included with the hardware option kit are available.
Procedure Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
HPE ProLiant DL360 Gen11 Server User Guide 57