HPE ProLiant DL360 Gen11 User Manual page 66

8. Install the access panel .
9. Install the server in the rack.
10. Connect each power cord to the server.
11. Connect each power cord to the power source.
12. Power up the server.
Results Results
The installation is complete.
Installing the 4LFF optical drive Installing the 4LFF optical drive
Prerequisites Prerequisites
Before installing this option, be sure that you have the following:
The components included with the hardware option kit
T-10 Torx screwdriver
LFF optical cable option kit
An optical drive
Procedure Procedure
1. Back up all server data.
2. Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Do one of the following:
a. Extend the server from the rack .
b. Remove the server from the rack .
5. Remove the LFF optical drive bay blank.
HPE ProLiant DL360 Gen11 Server User Guide 66