HPE ProLiant DL360 Gen11 User Manual page 59

11. Connect each power cord to the server.
12. Connect each power cord to the power source.
13. Power up the server .
Installing a PCIe network adapter Installing a PCIe network adapter
Prerequisites Prerequisites
Before installing this option, be sure you that have the following:
The components included with the hardware option kit
T-10 Torx screwdriver
Procedure Procedure
1. Observe the following alerts:
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the internal system WARNING:
components to cool before touching them.
CAUTION: To prevent damage to electrical components, properly ground the server before beginning any CAUTION:
installation procedure. Improper grounding can cause electrostatic discharge.
2. Back up all server data.
3. Power down the server.
4. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
5. Do one of the following:
a. Extend the server from the rack .
b. Remove the server from the rack .
6. Remove the access panel .
7. Do one of the following:
To install an adapter in slot 1 of the primary riser:
a. Remove the primary PCI riser cage.
b. Remove the blank.
c. Install the adapter.
HPE ProLiant DL360 Gen11 Server User Guide 59