HPE ProLiant DL360 Gen11 User Manual page 52

11. Install the access panel .
12. Slide the server into the rack.
13. Connect each power cord to the server.
14. Connect each power cord to the power source.
15. Power up the server .
Results Results
The installation is complete.
Installing the serial port option Installing the serial port option
Prerequisites Prerequisites
Before installing this option, be sure you have the following:
The components included with the hardware option kit
5 mm nut driver
Procedure Procedure
1. Observe the following alerts:
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the internal system WARNING:
components to cool before touching them.
CAUTION: To prevent damage to electrical components, properly ground the server before beginning any CAUTION:
installation procedure. Improper grounding can cause electrostatic discharge.
2. Back up all server data.
3. Power down the server.
4. Remove all power:
a. Disconnect each power cord from the power source.
HPE ProLiant DL360 Gen11 Server User Guide 52