HPE ProLiant DL360 Gen11 User Manual page 96

14. Connect each power cord to the server.
15. Connect each power cord to the power source.
16. Power up the server.
Installing a GPU in the primary riser cage Installing a GPU in the primary riser cage
Prerequisites Prerequisites
This option requires the standard primary PCI riser cage.
Before installing this option, be sure that the power supplies support the installation of this option.
In addition, be sure that you have the components included with the hardware option kit.
Procedure Procedure
1. Observe the following alerts:
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the internal system WARNING:
components to cool before touching them.
CAUTION: To prevent damage to electrical components, properly ground the server before beginning any CAUTION:
installation procedure. Improper grounding can cause electrostatic discharge.
2. Back up all server data.
3. Power down the server.
4. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
5. Do one of the following:
a. Extend the server from the rack .
b. Remove the server from the rack .
6. Remove the access panel .
7. Remove the primary PCI riser cage.
8. Install the GPU bracket.
9. Install the GPU in the riser cage.
If installing a GPU requiring greater than 75W, connect the power cable to the primary riser power connector.
HPE ProLiant DL360 Gen11 Server User Guide 96