HPE ProLiant DL360 Gen11 User Manual page 56

7. Install the access panel .
8. Slide the server into the rack.
9. Connect each power cord to the server.
10. Connect each power cord to the power source.
11. Power up the server .
Results Results
The installation is complete.
Installing a DIMM Installing a DIMM
Prerequisites Prerequisites
Before installing this option, be sure you have the following:
The components included with the hardware option kit
For more information on specific options, see the server QuickSpecs on the Hewlett Packard Enterprise
About this task About this task
The server supports up to 32 DIMMs.
Procedure Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
a. Extend the server from the rack .
b. Remove the server from the rack .
4. Remove the access panel .
5. Open the DIMM slot latches.
6. Install the DIMM.
Hewlett Packard Enterprise website website.
HPE ProLiant DL360 Gen11 Server User Guide 56