HPE ProLiant DL360 Gen11 User Manual page 39

3. Power down the server.
4. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
5. Do one of the following:
a. Extend the server from the rack .
b. Remove the server from the rack .
6. Remove the access panel .
7. Remove the primary riser cage.
8. Install the controller.
9. Install the riser cage.
10. Cable the controller .
11. Install the access panel .
12. Install the server in the rack.
13. Connect each power cord to the server.
14. Connect each power cord to the power source.
15. Power up the server .
Results Results
The installation is complete.
Installing a type-o storage controller Installing a type-o storage controller
Prerequisites Prerequisites
Before installing this option, be sure you that have the following:
The components included with the hardware option kit
T-10 Torx screwdriver
Procedure Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
HPE ProLiant DL360 Gen11 Server User Guide 39