Ordering Replacement Parts; Replacement Components - Covidien Valleylab LS10 Service Manual

Ordering Replacement Parts

Ordering Replacement Parts
Parts may be ordered from the Covidien Customer Service for your location.
When ordering replacement parts, include this information:
• Model number (located on the rear panel of the system)
• Serial number (located on the rear panel of the system)
• Part description (PCBA PROG MAIN, fan with cable)
• System configuration (dock generator to Valleylab Exchange Remote Software
System)
Use the system menus to identify the system configuration. See Instrument
Information on page 3-19.
– Software Build Part Number
– Main PCBA HW Revision
– Main PCBA HW Part Number
– Main PCBA HW Serial Number
– VIBE HW Part Number
– VIBE HW Revision
– VIBE HW Serial Number
If the information cannot be obtained, contact Covidien Technical Service (see page 7-4).

Replacement Components

Refer to Chapter 6, Replacement Procedures for step-by-step instructions for the removal
of the referenced components.
Precaution
Take proper ESD precautions when handling and replacing components. Irreversible damage may
occur due to static transfer if the component is handled improperly.
The following printed circuit board assemblies (PCBA) can be replaced:
• PCBA Display
• PCBA PROG MAIN
The following system components can be replaced:
• Front Panel Assembly
• Assy RFID/Barcode VIBE
• Power Supply
• Assy Receptacle LigaSure
• Speaker Assy
8-2 Valleylab LS10, LS Series Single Channel Vessel Sealing Generator Service Manual