Rse-X1 - H3C SR6604 Manual

NOTE:
SDRAM stores running configuration and buffers data during data forwarding.

RSE-X1

Figure2-5 RSE-X1 MPU
(1) Reset button (RESET)
(3) CF card
(5) Host-mode USB port 0 (0)
(7) USB 1 LED
(9) Management Ethernet port (MANAGEMENT)
(11) AUX port (AUX)
(13) Power alarm LED (PALM)
(15) System alarm LED (ALM)
Table2-5 RSE-X1 specifications
Item
Flash
Memory type and size
NVRAM
Console port
AUX port
Management Ethernet
port
CF card
USB ports
Reset button
Dimensions (H × W × D)
Power consumption
Hot swapping
1 2 3 4
Specification
4 MB
•
Default—Two 1-GB DDR2 SDRAMs
•
Maximum—Two 2-GB DDR2 SDRAMs
128 KB
1
9600 bps (default) to 115200 bps
1
9600 bps (default) to 115200 bps
1 (10Base-T/100Base-TX/1000Base-T)
•
256 MB by default for the built-in CF card
•
256 MB, 512 MB, or 1 GB for an optional external CF card (CF cards less
than 256 MB are not supported)
2 (USB 0: Type A connector, operating in the host mode; USB 1: Type B
connector, operating in the device mode)
1
45 × 399 × 412 mm (1.77 × 15.71 × 16.22 in)
75 W
Supported
2-5
5 6 7 8 9 10
(2) CF card button
(4) CF card LED
(6) Device-mode USB port 1 (1)
(8) LINK/ACT LED for the Ethernet management
port
(10) Console port (CONSOLE)
(12) Active/Standby LED (ACT)
(14) RUN LED
11 12 14
13 15