Parts Identification; Converter Unit (Mr-Hp-30Ka/Mr-Hp55Ka4) - Mitsubishi Electric MELSERVO MR-HP30KA Instruction Manual

1. FUNCTIONS AND STRUCTURE

1.7 Parts identification

The rating plate is on the right side face when viewed from the front.

1.7.1 Converter unit (MR-HP-30KA/MR-HP55KA4)

TE2-1
TE1-1
Downloaded from ManualsNet.com
TE2-2
TE3
TE1-2
search engine
Name/Application
TE2-1, TE2-2 (PN terminals)
Connect to the servo amplifier using the connection
conductors supplied to the servo amplifier.
Display
The four-digit, seven-segment LED shows the servo
status and alarm number.
Operation section
Used to perform status display, diagnostic, alarm and
parameter point table operations.
MOVE UP DOWN SET
CN1
Outputs an alarm signal.
CN3
For maker adjustment. Leave this open.
CN6
For maker adjustment. Leave this open.
CN5
Connect to CN5A of the servo amplifier.
Charge lamp
Lit to indicate that the main circuit is charged. While
this lamp is lit, do not reconnect the cables.
(Ground terminal)
TE1-2
Supply main circuit power.
TE1-1
Connect the regenerative brake option or power factor
improving DC reactor.
TE3
Supply control circuit power.
1 - 9
Refer To
Section
3.3.2
Section
7.1
Chapter 4
Used to set data.
Used to change the
display data in each
mode.
Used to change the
mode.
Section 3.1.1
Section 3.3.2
Section 3.3.2
Section 3.3.2
Section 3.3.2