Installation - Omron K7DD User Manual

3 Installation and Wiring
3-2

Installation

Mounting to DIN Track
• Pull down the DIN Track mounting hook on
the bottom of the K7DD.
• Next, hook the upper hook onto the DIN
Track and push in the Unit.
• Finally, raise the DIN Track mounting hook
that was pulled down and fix the Unit to the
DIN Track.
 Installation Orientation
Install and use the K7DD with upright
installation direction.
Installation of End Plates
• Install End Plates on the right and left sides of the K7DD.
Install an End Plate at each end of the K7DD.
To install an End Plate, 1) hook the bottom on the bottom of the
track, 2) hook the top of the Plate on the top of the track, and then
tighten the screw to lock the Plate in place.
 Recommended DIN Track
Model
PFP-100N
PFP-50N
 Recommended End Plates
Model
PFP-M
Removing from the DIN Track
• Pull out the DIN Track mounting hook with a flat-blade
screwdriver and lift the Unit from the bottom to remove it.
• The K7DD can be easily installed and removed if the distance to
other devices is 30 mm or above.
3 - 4
Specifications
1,000 mm long × 35 mm wide × 7.3 mm high OMRON
500 mm long × 35 mm wide × 7.3 mm high
Specifications
For PFP-100N/PFP-50N
(1) (2)
End
Plate
Manufacturer
OMRON
Manufacturer
OMRON
Power Line Data Generator User's Manual (N233)
(3)
2）
1）
End
Plate
30 mm min