Omron K7DD User Manual page 134

7 Communications
• The variable addresses of CH3 start with
H'5000.
• The variable addresses of CH1, CH2, and CH3
start with H'0000.
This manual describes only the variable addresses of CH1 so as to simplify the description.
When you use a variable address of CH2, change the beginning of the variable address of CH1 into 3 or 4 before use.
When you use a variable address of CH3, change the beginning of the variable address of CH1 into 5 or 6 before use.
Example: (CH1) H'1000 → (CH2) H'3000 → (CH3) H'5000
(CH1) H'2000 → (CH2) H'4000 → (CH3) H'6000
To write via communications a variable whose setting reflection timing is "After restart,"
you need to execute the Operation Stop Status Transition Command (Operation
Command) or move to the Initial Setting Level with Key operations beforehand.
7 - 18
Example:
Variable
Channel
address
Both CH1 H'5000 Measurement Status
and CH2
H'5001 Monitoring Status
H'5002 to Reserved
H'500F
H'5010 CH Feature [ID:0] Monitoring
H'5011 CH Feature [ID:1] Monitoring
: :
H'509C CH Feature [ID:140]
H'509D Monitoring
CH Feature [ID:141]
Monitoring
• •
• •
• •
Example:
Variable
Channel
address
Common H'0000 K7DD Status
to CH1,
H'0001 to Reserved
CH2, and
H'0070
CH3
H'0080 Monitored Feature [0] Monitor
H'0081 Ch 1
H'0082 Monitored Feature [0] Monitor
: Ch 2
H'00A4 Monitored Feature [0] Monitor
H'00A5 Ch 1
H'00A6 :
Monitored Feature [12]
Monitor Ch 1
Monitored Feature [12]
Monitor Ch 2
Monitored Feature [12]
Monitor Ch 1
• •
• •
• •
Power Line Data Generator User's Manual (N233)
Variable name
•
•
•
Variable name
•
•
•
Setting
reflection
timing
Immediately
After restart