K7Dd Basic Settings - Omron K6CM Usage Manual

2 Basic Settings
2-5

K7DD Basic Settings

The Initial Settings and Trigger Settings in the Basic Settings are described below. Refer to 1-3 Com-
munication Settings (Home Screen (2)) for information on Communication Settings.
K7DD Initial Settings
This is the Initial Settings Screen in the Basic
Settings.
Setting parameters are as follows:
Advanced Motor Condition Monitoring Device
K7DD-PQ
*1. The Wiring Method parameter is referred to as Wiring State parameter in the K7DD User's Manual.
K7DD Trigger Settings
The Trigger Settings are used to specify the measurement timing conducted by the condition
monitoring device.
The trigger settings specify only the timing when the drive frequency does not change and remains a
constant value, in order to measure accurately.
If noise is induced when the equipment starts up or is unstable, set the measurement timing while
taking into consideration the time required for noise removal over a specified period.
For details on K7DD trigger settings, refer to Accurate Monitoring with Trigger Settings in 2-1 Overview
of Operating Procedures of the K7DD User's Manual (N233).
This is the Trigger Settings Screen in the
Basic Settings.
Setting parameters are as follows:
Advanced Motor Condition Monitoring Device
K7DD-PQ
For details on setting parameters, hover your mouse over the "i" mark on the screen to display hints
and instructions. Set the parameters according to those instructions.
34
Initial Settings
Setting Parameter
Wiring Method*1, Current Input Range, Voltage Input Range
Trigger Settings
Setting Parameter
Trigger Mode, Trigger Source, Trigger type, Trigger Level,
Delay Count, Measure Count
Condition Monitoring Configuration Tool Usage Guide (N240)