SECTION 1
Wiring and Connection
1-1 Basic System Configuration
NOTICE
CHECK
Z500
20
Setup Manual
• The following diagram shows the basic Z500 system configuration. Some of the compo-
nents shown in the configuration diagram are special OMRON products that cannot be substi-
tuted with comparable devices. These items are indicated with an asterisk.
• Always turn OFF the power supply before connecting or disconnecting cables. The periph-
eral device may be damaged if connected or disconnected with the power supply turned
ON.
Sensor
*
Z500-SW2T (2-m cable)
Z500-SW6 (Can be connected to controller of Ver. 1.2 or upper grade; 0.5-m cable)
Z500-SW17 (2-m cable)
• Up to 2 Sensors can be connected.
• To replace the sensor being connected to the controller, turn OFF the download function.
REFERENCE
Refer to page 146 in the Operation Manual.
* Sensor Extension Cable
Z309-SC1R (1.5 m, 3 m, 6 m, 8 m or 13 m)
Specify the required cable length when ordering.