FUTABA 16SZ Instruction Manual page 92

Sensor：Reload
When using multiple sensors of the same type
the sensors must be registered in the transmitter.
the following procedure. The ID of each sensor is
registered in the transmitter.
Reading all the sensors to be used
Sensor : Register
This function registers an additional sensor.
Connect the sensor as shown in the figure at the
right and register it by the following procedure.
The sensor ID is registered in the transmitter.
Additional sensor registration
This page is set when using multiple telemetry sensors of the same type.
This page is set when using multiple telemetry sensors of the same type.
Hub
Hub
*It is not necessary to carry out
multiple battery connections like
*When the number of slots needed in
registration is insufficient, an error is
displayed and registration cannot be
performed. Disable unused slots or
perform the following reload.
＜ Linkage menu ＞
Hub
Receivers
Battery
93