Telemetry: Voltage [Battery]
In this screen, the battery voltage is displayed.
In order to use this function, it is necessary to
⇔
battery connected to two lines is displayed on EXT-
lines is displayed here.
Max. and min. values
s i n c e t h e p o w e r
was turned ON will
display.
↓ The "down" arrow
will indicate that an
alarm will sound when
the voltage drops to
below the setting.
Alarm is chosen from
Buzzer, Voice, and
Inhibit.
Allows Speech to be
turned ON or OFF.
Alarm set
*When the screen is tapped for one second, the rate is
reset to the initial value.
wiring.
< Linkage menu >
104
*SBS-01V must be installed in the aircraft.
In this screen, the battery voltage of a receiver is
displayed.
⇔
If it becomes higher or lower than the settin, an
alarm and/or vibration will alert you.
*Only receiver voltage and EXT voltage can be used in
functions.
Vibrator choices are
type1-3, and Inhibit.
<
Two drive batteries are measured (R7008SB use)
Drive battery 1
(EXT Battery)
Drive battery 2
t
(EXT Battery)
Receiver battery
Two drive batteries and power supplies for servos are measured (R7008SB use)
Drive battery 1
(EXT Battery)
Drive battery 2
(EXT Battery)
Power supplies
for servos
S.BUS2
servos
Battery voltage
Sets the voltage on
which the alarm
operates.
EXT Line
Normal Line
●Battery voltage measurement for receivers [R7008SB use]
●The drive battery 1 is measured in an EXT port [R7008SB use]
●The drive battery 2 is measured in an EXT line [SBS-01V use]
*SBS-01V measures two voltage. One corresponds to high voltages, such as a drive battery,
with an EXT line. Another is a normal line and is measurement of the battery for receivers of a
line connected to 3P connector, or the battery for servos.
EXT Line
Normal Line
Receiver battery
●Battery voltage measurement for receivers [R7008SB use]
●The drive battery 1 is measured in an EXT port [R7008SB use]
●The drive battery 2 is measured in an EXT line [SBS-01V use]
●The voltage for servos is measured in a power supply line [SBS-01V use]
>