Telemetry : GPS [Distance]
The Distance screen displays and sets altitude
aircraft to be read by the transmitter. When the
aircraft flies inside or outside the set distance, an
alarm and vibration alerts the pilot.
Max. and min. values
s i n c e t h e p o w e r
was turned ON will
display.
↑ An upward arrow
indicates the alarm
will sound when the
d i s t a n c e r e a c h e s
above your set value.
↓ A downward arrow
indicates the alarm
will sound when the
d i s t a n c e r e a c h e s
below your set value.
Alarm is chosen from
Buzzer, Voice, and
Inhibit.
Allows Speech to be
turned ON or OFF.
"Vibrator" type
If the following types are selected, the transmitter
will vibrate during the warning.
Type 1
Type 2
Type 3
< Linkage menu >
106
*A GPS sensor must be installed in the aircraft.
Tap to the [Preset] of "Reference"
item. Sets the current aircraft position
as the starting point.
Altitude calculated as either straight line distance
(slant) or surface distance on a map can also be
selected.
Select <Slant> <Surface> to "Distance mode", tap the
screen.
and connect the sensor in accordance with the sensor
instruction manual.
*Only receiver voltage and EXT voltage can be used in
functions.
Surface
Distance
Sets the distance
on which the alarm
operates.
Altitude