Table of Contents
Advertisement
Condition select
The functions in the Model menu can be used by
switching the settings of up to 8 flight conditions
conditions. Add conditions, as required.
When you do not want to use the Condition
select function, this setting is unnecessary. In this
case, use the flight conditions assigned at initial
setting.
addition to ordinary toggle switch, is possible
as the flight condition selector switch, this
Unnecessary fuselage motion generated
call the setup screen shown below.
Conditions List
1 . S e l e c t t h e c o n d i t i o n b y
tapping the condition you
List.
2. Tap the [Rename] button.
3. Enter the new name from the
the screen.
name is registered.
122
＜ Model menu (Common Functions) ＞
Flight condition's addition, deletion, copy, condition renaming,
and condition delay can be set. [All model types]
when there are sudden changes in the servo
positions and when there are variations in
the operating time between channels during
condition switching can be suppressed. The
delay can be set for each channel.
When setting the delay function at the
s w i t c h i n g d e s t i n a t i o n c o n d i t i o n , t h e
related function changes after a delay
corresponding to the set amount.
operation priority can be freely changed.
selected condition name is displayed on
the screen. When a condition has been
added, give it a name which can be easily
Currently selected condition name
1. When the [Add] button is tapped, the
*Only the number of buttons corresponding to the
conditions which can be added are displayed.
2. Select the desired conditions by tapping
the buttons.
*The selected conditions are added to Conditions
List.
3. Tap the [--] button to call the <Switch>
screen.
4. Select the switch to be used in condition
switching.
(See "Switch selection method" at the end
of this manual for selection method
details.)
conditions is copied.
Advertisement
Table of Contents
